| |
|
|
 |
|
| Measure each window individually as sizes may vary.
Record width first, then height (length) to the nearest 1/8”.
Measure width from left to right, height from top to bottom using a
metal tape measure. PLEASE DO NOT USE A CLOTH TAPE! |
|
 |
| Inside Mount |
|
Inside mount blinds are installed inside the window
frame. |
- Measure the exact inside width of window
frame from one inside edge to the other. Take
three measurements, one near the top, one in
the center and one near the bottom. Record the
narrowest measurement.
- Measure the exact height in three places,
left, center and right from top edge of opening
to top of sill. Record the longest measurement
for horizontal blinds.
- Do not take deductions on inside mount
measurements. The factory will take an 1/2“
allowances for operating clearance.
- Measure the window diagonally in two places
as shown. If the two diagonal measurements are
not the same, we suggest an outside mount
application for the best shade performance and
appearance.
|
|
 |
| Outside Mount |
|
Outside mount blinds are installed outside the window
frame, covering an area larger than the window
itself. |
- Measure the exact width of area to be
covered. Be certain the measurement overlaps
the window opening by at least 1 1/2” on each
side to ensure privacy and light control.
- Measure exact height to be covered,
including desired overlap (usually from top
edge of molding to bottom edge, or to top of
sill). If there is no sill, measure to where
the blind is to reach.
- The factory does not make deductions for an
outside mount.
|
|
|
|
| |
|
|
